Open in the explorer

Configure default networking mode

Type
Computer
GPO path
Computer Configuration › Policies › Administrative Templates › Windows Subsystem for Linux
Supported on
SUPPORTED_Windows10
ADMX file
WSL.admx
Internal name
WSL/DefaultNetworkingMode

Explanation

This policy specifies the default networking mode to be used for WSL2.

Registry

HKEY_LOCAL_MACHINE\Software\Policies\WSL
Value name
DefaultNetworkingMode
StateValue written
Enablednot defined in the ADMX (see the options below)
Disablednot defined in the ADMX (see the options below)

PowerShell

PowerShell commands that write to the registry what the policy would write. Values in angle brackets (<…>) must be replaced.

The ADMX does not specify the value written when enabled; the GPO editor usually writes REG_DWORD 1 (enabled) / 0 (disabled). The commands below use 1/0 as an assumption.

Writing directly to the registry bypasses Group Policy: if a GPO manages this value, it will be rewritten at the next gpupdate; otherwise the value stays in place (the "tattooing" effect). Prefer a GPO or, locally, LGPO.exe. Run PowerShell as administrator for HKLM. Some policies need a restart or gpupdate /force.

Enable

# Enable: WSL/DefaultNetworkingMode
$k = 'HKLM:\Software\Policies\WSL'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
# The ADMX does not specify the value written; the GPO editor usually writes REG_DWORD 1 (enabled) / 0 (disabled)
Set-ItemProperty -Path $k -Name 'DefaultNetworkingMode' -Value 1 -Type DWord  # assumed value (not defined in the ADMX)
# Default Networking Mode
# Possible options:
#   None = 0
#   NAT = 1
#   Mirrored = 3
#   Consomme = 4
Set-ItemProperty -Path $k -Name 'DefaultNetworkingMode' -Value 1 -Type DWord

Disable

# Disable: WSL/DefaultNetworkingMode
$k = 'HKLM:\Software\Policies\WSL'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
# The ADMX does not specify the value written; the GPO editor usually writes REG_DWORD 1 (enabled) / 0 (disabled)
Set-ItemProperty -Path $k -Name 'DefaultNetworkingMode' -Value 0 -Type DWord  # assumed value (not defined in the ADMX)

Revert to "Not configured"

# Revert to "Not configured": WSL/DefaultNetworkingMode
$k = 'HKLM:\Software\Policies\WSL'
Remove-ItemProperty -Path $k -Name 'DefaultNetworkingMode' -ErrorAction SilentlyContinue

Options (1)

LabelControlRegistry valueREG typeConstraints / details
Default Networking ModeDefaultNetworkingMode_DropdownDrop-down listenumDefaultNetworkingModeREG_DWORD
Default choice (UI): #1
LabelValue
NoneREG_DWORD = 0
NATREG_DWORD = 1
MirroredREG_DWORD = 3
ConsommeREG_DWORD = 4

Application

Windows Subsystem for Linux (WSL) (Microsoft) — November 2026 templates

Official templates downloaded on November 12, 2026.