Turn on reparse point scanning
Activer l’analyse des points d’analyse
Explanation
This policy setting allows you to configure reparse point scanning. If you allow reparse points to be scanned, there is a possible risk of recursion. However, the engine supports following reparse points to a maximum depth so at worst scanning could be slowed. Reparse point scanning is disabled by default and this is the recommended state for this functionality.
If you enable this setting, reparse point scanning will be enabled.
If you disable or do not configure this setting, reparse point scanning will be disabled.
Ce paramètre de stratégie vous permet de configurer l’analyse des points d’analyse. Si vous autorisez l’analyse des points d’analyse, il existe un risque possible de récursivité. Toutefois, le moteur prenant en charge les points d’analyse suivants jusqu’à une profondeur maximale, l’analyse peut au pire être ralentie. L’analyse des points d’analyse est désactivée par défaut et il s’agit de l’état recommandé pour cette fonctionnalité.
Si vous activez ce paramètre, l’analyse des points d’analyse est activée.
Si vous désactivez ou ne configurez pas ce paramètre, l’analyse des points d’analyse est désactivée.
Registry
HKEY_LOCAL_MACHINE\Software\Policies\Microsoft\Windows Defender\Scan- Value name
DisableReparsePointScanning
| State | Value written |
|---|---|
| Enabled | REG_DWORD = 0 |
| Disabled | REG_DWORD = 1 |
PowerShell
PowerShell commands that write to the registry what the policy would write. Values in angle brackets (<…>) must be replaced.
Writing directly to the registry bypasses Group Policy: if a GPO manages this value, it will be rewritten at the next gpupdate; otherwise the value stays in place (the "tattooing" effect). Prefer a GPO or, locally, LGPO.exe. Run PowerShell as administrator for HKLM. Some policies need a restart or gpupdate /force.
Enable
# Enable: WindowsDefender/Scan_DisableReparsePointScanning
$k = 'HKLM:\Software\Policies\Microsoft\Windows Defender\Scan'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
Set-ItemProperty -Path $k -Name 'DisableReparsePointScanning' -Value 0 -Type DWordDisable
# Disable: WindowsDefender/Scan_DisableReparsePointScanning
$k = 'HKLM:\Software\Policies\Microsoft\Windows Defender\Scan'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
Set-ItemProperty -Path $k -Name 'DisableReparsePointScanning' -Value 1 -Type DWordRevert to "Not configured"
# Revert to "Not configured": WindowsDefender/Scan_DisableReparsePointScanning
$k = 'HKLM:\Software\Policies\Microsoft\Windows Defender\Scan'
Remove-ItemProperty -Path $k -Name 'DisableReparsePointScanning' -ErrorAction SilentlyContinue