Open in the explorer

Enable site isolation for every site

Type
Computer and user
GPO path
Computer Configuration › Policies › Administrative Templates › Microsoft Edge User Configuration › Policies › Administrative Templates › Microsoft Edge
Supported on
Microsoft Edge version 77, Windows 7 or later
ADMX file
msedge.admx
Internal name
msedge/SitePerProcess

Explanation

The 'SitePerProcess' policy can be used to prevent users from opting out of the default behavior of isolating all sites. You can also use the 'IsolateOrigins' (Enable site isolation for specific origins) policy to isolate additional, finer-grained origins.

If you enable this policy, users can't opt out of the default behavior where each site runs in its own process.

If you disable or don't configure this policy, a user can opt out of site isolation. (For example, by using "Disable site isolation" entry in edge://flags.) Disabling the policy or not configuring the policy doesn't turn off Site Isolation.

Registry

HKEY_LOCAL_MACHINE\Software\Policies\Microsoft\Edge
HKEY_CURRENT_USER\Software\Policies\Microsoft\Edge
Value name
SitePerProcess
StateValue written
EnabledREG_DWORD = 1
DisabledREG_DWORD = 0

PowerShell

PowerShell commands that write to the registry what the policy would write. Values in angle brackets (<…>) must be replaced.

Writing directly to the registry bypasses Group Policy: if a GPO manages this value, it will be rewritten at the next gpupdate; otherwise the value stays in place (the "tattooing" effect). Prefer a GPO or, locally, LGPO.exe. Run PowerShell as administrator for HKLM. Some policies need a restart or gpupdate /force.

Computer (HKLM)

Enable

# Enable: msedge/SitePerProcess
$k = 'HKLM:\Software\Policies\Microsoft\Edge'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
Set-ItemProperty -Path $k -Name 'SitePerProcess' -Value 1 -Type DWord

Disable

# Disable: msedge/SitePerProcess
$k = 'HKLM:\Software\Policies\Microsoft\Edge'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
Set-ItemProperty -Path $k -Name 'SitePerProcess' -Value 0 -Type DWord

Revert to "Not configured"

# Revert to "Not configured": msedge/SitePerProcess
$k = 'HKLM:\Software\Policies\Microsoft\Edge'
Remove-ItemProperty -Path $k -Name 'SitePerProcess' -ErrorAction SilentlyContinue

User (HKCU)

Enable

Disable

Revert to "Not configured"

Application

Microsoft Edge (+ Edge Update, WebView2) (Microsoft) — November 2026 templates

Official templates downloaded on November 12, 2026.