Enable authentication rate limiter
Activer le limiteur de débit d’authentification
Explanation
This policy controls whether the SMB server will enable or disable the authentication rate limiter.
If you disable this policy setting, the authentication rate limiter will not be enabled.
If you do not configure this policy setting, the authentication rate limiter may still be working depending on the delay settings (the recommended delay value is 2000ms).
Cette stratégie contrôle si le serveur SMB active ou désactive le limiteur de taux d’authentification.
Si vous désactivez ce paramètre de stratégie, le limiteur de taux d’authentification n’est pas activé.
Si vous ne configurez pas ce paramètre de stratégie, le limiteur de taux d’authentification peut continuer à fonctionner en fonction des paramètres de délai (la valeur de délai recommandée est 2 000 ms).
Use cases
Enables the SMB server authentication rate limiter, which adds a 2-second delay after each failed NTLM or local KDC Kerberos attempt: an attack at 300 guesses per second for 5 minutes would take about 50 hours. It is on by default.
Disabling it only makes sense for testing; leave it on for exposed servers.
Microsoft source: SMB security hardening
Registry
HKEY_LOCAL_MACHINE\Software\Policies\Microsoft\Windows\LanmanServer- Value name
EnableAuthRateLimiter
| State | Value written |
|---|---|
| Enabled | REG_DWORD = 1 |
| Disabled | REG_DWORD = 0 |
PowerShell
PowerShell commands that write to the registry what the policy would write. Values in angle brackets (<…>) must be replaced.
Writing directly to the registry bypasses Group Policy: if a GPO manages this value, it will be rewritten at the next gpupdate; otherwise the value stays in place (the "tattooing" effect). Prefer a GPO or, locally, LGPO.exe. Run PowerShell as administrator for HKLM. Some policies need a restart or gpupdate /force.
Enable
# Enable: LanmanServer/Pol_EnableAuthRateLimiter
$k = 'HKLM:\Software\Policies\Microsoft\Windows\LanmanServer'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
Set-ItemProperty -Path $k -Name 'EnableAuthRateLimiter' -Value 1 -Type DWordDisable
# Disable: LanmanServer/Pol_EnableAuthRateLimiter
$k = 'HKLM:\Software\Policies\Microsoft\Windows\LanmanServer'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
Set-ItemProperty -Path $k -Name 'EnableAuthRateLimiter' -Value 0 -Type DWordRevert to "Not configured"
# Revert to "Not configured": LanmanServer/Pol_EnableAuthRateLimiter
$k = 'HKLM:\Software\Policies\Microsoft\Windows\LanmanServer'
Remove-ItemProperty -Path $k -Name 'EnableAuthRateLimiter' -ErrorAction SilentlyContinue