Do not allow adding new targets via manual configuration
Ne pas autoriser l’ajout de nouvelles cibles via la configuration manuelle
Explanation
If enabled then new targets may not be manually configured by entering the target name and target portal; already discovered targets may be manually configured. If disabled then new and already discovered targets may be manually configured. Note: if enabled there may be cases where this will break VDS.
Si ce paramètre est activé, les nouvelles cibles ne pourront pas être configurées manuellement par la saisie du nom cible et du portail cible ; en revanche, les cibles déjà découvertes pourront être configurées manuellement. Si ce paramètre est désactivé, les cibles nouvelles et déjà découvertes pourront être configurées manuellement. Remarque : s’il est activé, il est possible que ce paramètre interrompe le service VDS dans certains cas.
Registry
HKEY_LOCAL_MACHINE\Software\Policies\Microsoft\Windows\iSCSI- Value name
NewStaticTargets
| State | Value written |
|---|---|
| Enabled | REG_DWORD = 1 |
| Disabled | REG_DWORD = 0 |
PowerShell
PowerShell commands that write to the registry what the policy would write. Values in angle brackets (<…>) must be replaced.
Writing directly to the registry bypasses Group Policy: if a GPO manages this value, it will be rewritten at the next gpupdate; otherwise the value stays in place (the "tattooing" effect). Prefer a GPO or, locally, LGPO.exe. Run PowerShell as administrator for HKLM. Some policies need a restart or gpupdate /force.
Enable
# Enable: iSCSI/iSCSIDiscovery_NewStaticTargets
$k = 'HKLM:\Software\Policies\Microsoft\Windows\iSCSI'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
Set-ItemProperty -Path $k -Name 'NewStaticTargets' -Value 1 -Type DWordDisable
# Disable: iSCSI/iSCSIDiscovery_NewStaticTargets
$k = 'HKLM:\Software\Policies\Microsoft\Windows\iSCSI'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
Set-ItemProperty -Path $k -Name 'NewStaticTargets' -Value 0 -Type DWordRevert to "Not configured"
# Revert to "Not configured": iSCSI/iSCSIDiscovery_NewStaticTargets
$k = 'HKLM:\Software\Policies\Microsoft\Windows\iSCSI'
Remove-ItemProperty -Path $k -Name 'NewStaticTargets' -ErrorAction SilentlyContinue