Disable full duplex Audio
Désactiver le son en duplex intégral
Explanation
Disables full duplex mode audio. Users will not be able to listen to incoming audio while speaking into the microphone. Older audio hardware does not perform well when in full duplex mode.
Désactive le mode audio en duplex intégral. Les utilisateurs ne peuvent pas écouter de son entrant tout en parlant dans le micro. Le matériel audio plus ancien ne fonctionne pas correctement en mode duplex intégral.
Registry
HKEY_CURRENT_USER\Software\Policies\Microsoft\Conferencing- Value name
NoFullDuplex
| State | Value written |
|---|---|
| Enabled | not defined in the ADMX |
| Disabled | not defined in the ADMX |
PowerShell
PowerShell commands that write to the registry what the policy would write. Values in angle brackets (<…>) must be replaced.
The ADMX does not specify the value written when enabled; the GPO editor usually writes REG_DWORD 1 (enabled) / 0 (disabled). The commands below use 1/0 as an assumption.
Writing directly to the registry bypasses Group Policy: if a GPO manages this value, it will be rewritten at the next gpupdate; otherwise the value stays in place (the "tattooing" effect). Prefer a GPO or, locally, LGPO.exe. Run PowerShell as administrator for HKLM. Some policies need a restart or gpupdate /force.
Enable
# Enable: Conf/PreventFullDuplex
$k = 'HKCU:\Software\Policies\Microsoft\Conferencing'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
# The ADMX does not specify the value written; the GPO editor usually writes REG_DWORD 1 (enabled) / 0 (disabled)
Set-ItemProperty -Path $k -Name 'NoFullDuplex' -Value 1 -Type DWord # assumed value (not defined in the ADMX)Disable
# Disable: Conf/PreventFullDuplex
$k = 'HKCU:\Software\Policies\Microsoft\Conferencing'
if (-not (Test-Path -Path $k)) { New-Item -Path $k -Force | Out-Null }
# The ADMX does not specify the value written; the GPO editor usually writes REG_DWORD 1 (enabled) / 0 (disabled)
Set-ItemProperty -Path $k -Name 'NoFullDuplex' -Value 0 -Type DWord # assumed value (not defined in the ADMX)Revert to "Not configured"
# Revert to "Not configured": Conf/PreventFullDuplex
$k = 'HKCU:\Software\Policies\Microsoft\Conferencing'
Remove-ItemProperty -Path $k -Name 'NoFullDuplex' -ErrorAction SilentlyContinue